Extended Roll Holders
Extended Roll Holders
No. 44 extended Roll Holders For Roller Back Rests 00, 0 and 2 Sizes
When these holders are in operating position in the tool, the rolls are positioned ahead of the blade by approximately the thickness of the roll. This permits turning diameters
concentrically with previously turned diameters. They are furnished in pairs complete with rolls and pins.
| Tools Where Used | Tool No. |
| 51-100 & 52-100 | 711-44-100 |
| 51-320 & 52-220
53-122 & 54-122 |
711-44-120 |
| 51-322 & 52-222 | 711-44-122 |
Extended Roll Holders For Roller Box Tools
The same holders are used on both left and right hand tools. They are furnished in Pairs. These holders permit turning diameters concentrically with previously turned diameters.
| Tools Used With | Tool No. |
| 51-200 & 52-200 | 711-44-200 |
| 51-420 & 53-222 & 54-222 | 711-44-220 |
| 51-422 & 52-322 | 711-44-222 |
| Tool No. | 711-44-100 | 711-44-120 | 711-44-122 | 711-44-200 | 711-44-220 | 711-44-222 |
| Roll | 711-55-100 | 711-55-120 | 711-55-122 | 711-55-100 | 711-55-120 | 711-55-122 |
| Roll Pin | 211-5126 | 211-5127 | 211-5125 | 211-5126 | 211-5127 | 211-5125 |
| Set Screw | 92-5390-608 | 92-5390-612 | 92-5390-620 | 92-5390-620 | 95-5390-608 | 92-5390-620 |
| Tapered Rolls | |||||
| Tool Size | O.D. | Width | Hole | Tool No. | Pin No. |
| 00 | 5/16” | 5/32” | 1/8” | 711-56-100 | 211-5126 |
| 0*# | 7/16” | 3/16” | 3/16” | 711-56-120 | 211-5127 |
| 2 | 5/8” | 1/4” | 1/4” | 711-56-122 | 211-5125 |
| Straight Rolls | |||||
| Tool Size | O.D. | Width | Hole | Tool No. | Pin No. |
| 00 | 5/16” | 5/32” | 1/8” | 711-55-100 | 211-5126 |
| 0*# | 7/16” | 3/16” | 3/16” | 711-55-120 | 211-5127 |
| 2 | 5/8” | 1/4” | 1/4” | 711-55-122 | 211-5125 |